| From: | Hans-Joerg Frieden |
| Date: | 7 Apr 2000 at 15:51:33 |
| Subject: | Re: Problems with Warp3D 3.0 |
On 6 Apr 2000, Andy Thomson wrote:
> I have an Amiga 4000 with a 68060/50 and a CyberVision3D card. I have
> tried to install Warp3D from the last AF CD. The gears demo does not
> run correctly, it corrupts the display. So I ran WarpTest, this gives
> a few lines about the ViRGE chip and what it can do but then says the
> Mode ID is not found and quits. I checked the libraries, they are
> there. I checked H&P hope page and installed the StormMesa Libs but
> the problem still persists. Have I missed a step? Does an ENV variable
> need setting?
This information is a bit thin. What Cybergraphics version do you
have? Do you have the correct driver installed? Correct library
versions? Did you check Problems.txt and compare the settings/version
numbers there? The "Missing ModeID" is usually a sign of a incomplete
or faulty installation.
Also check the settings in the Monitor tooltype.
For more information, you might also want to check out Paul's FAQ.
Regards, Hans-Joerg.